BMW 740i/iL Trunk Shock Replacement Procedure.Pdf

PDF Preview :

BMW 740i/iL Trunk Shock Replacement Procedure~The procedure took only about 30 minutes and was very easy. The outcome was excellent making the project well worth it and highly recommended.

Procedure:
non government
1. It is best to remove and replace one shock and then move to the other side. Without any shock the trunk will easily fall on your head. To be safe, you may want to prop the trunk lid so it cannot fall on your head. When I had one shock removed, the wind did blow the lid down on my head!
2. Begin with the driver side shock. I recommend this because it is slightly easier since the wiring/harness does not come into play.
3. First, remove the c-clip of the upper mount, but do not disconnect the shock from the pivot mount yet. Here is picture with c-clip already removed. Another tip, I suggest replacing since cheap, but regardless, when you attempt to remove try to cover the clip with a rag so it doesn’t go flying. Mine disappeared out in the yard somewhere.
4. The next step is to remove the lower mounting clip. This is accomplished by using a screwdriver to push the clip downward and off the shock.
5. Now the driver side shock can be removed. Simply pull the lower part straight out and pull the upper mount off the pivot shaft. Again, be careful here that the trunk stays up and not on your skull.
6. Next install the new drivers side trunk shock. But first clean off the upper mount shaft and the lower ball joint. It really isn’t necessary to grease these connections because the new shock comes with grease already in the part.

Download Free ebook BMW 740i/iL Trunk Shock Replacement Procedure.Pdf

BMW SRI Manual Reset 2001.Pdf

PDF Preview :

"BMW SRI Manual Reset 2001"~On 2001 vehicles without the diagnostic connector in the engine compartment, the use of the SIA reset tool is not possible. The service indicator may be reset using the reset mode in the instrument cluster.

Reset procedure for high and low clusters with SIA III using the Reset Mode:
• Ignition key must be “off”
• Press and hold the trip odometer reset button in the instrument cluster (left button), and turn the ignition key to the first position.
• Keep the button pressed for approximately 5 seconds until one of the following words appear in the display: “OIL SERVICE, or “INSPECTION”, with “RESET”.
The service due is shown with “reset” if the coded minimum consumption limit has been reached and resetting is possible. If “reset” is not shown, the minimum limit has not been reached and resetting is not possible.
• Press and hold the reset button again until the word “RESET” begins to flash.

Download Free ebook BMW SRI Manual Reset 2001.Pdf

Parts and Accessories Installation Instructions Pdf

Content Preview :

Parts and Accessories. Installation Instructions. DVD Navigation System Retrofit with On-Board Monitor BMW 3 Series Coupé (E 46/2) BMW 3 Series Saloon (E 46/4) These installation instructions are only valid for cars with SA 534 (automatic air conditioning) and SA 550 (on-board computer). Retrofit kit No. 65 90 0 391 113 Installation time The installation time is approx. 5.5 hours, but this may vary depending on the condition of the car and the equipment in it. Important information These installation instructions are primarily designed for use within the BMW dealership organisation and by authorised BMW service companies. In any event the target group for these installation instructions is specialist personnel trained on BMW cars with the appropriate specialist knowledge. All work must be completed using the latest BMW repair manuals, circuit diagrams, servicing manuals and work instructions in a rational order using the prescribed tools (special tools) and observing current health and safety regulations.

Download Free ebook Parts and Accessories.Installation Instructions.Pdf